Launch Pad V2 Full case

Launch Pad V2 Full case

from 28.00

LaunchPad V2 Full cases for SpaceCat’s LaunchPad V2 PCBs! These cases will not work with the V1 PCBs as they dont have the cutouts for the standoffs.

PCBs available here: https://spacecat.design/products/launch-pad

THICK, SINGLE PIECE FROST MIDDLES ARE LIMITED SUPPLY. I have a good amount of this material for the mid pieces for the LaunchPads but at some point I will run out and will not be able to stock it again for a long time.

The case will come with the standoffs and screws needed to assemble it (8mm standoffs). The middle pieces will be 3/8” thick which is enough room for the ProMicro to fit.

Cases will support combination of 1U and 2U layouts if you use PCB mount cherry stabs. Plates have engraved bottoms to allow for the stabs to fit under the 3mm plate.

Turnaround time: <2 weeks

Top/Bot Color:
Middle color:
Quantity:
Add To Cart